Rig # 14 Inventory
Draw Works 6,000 feet Rated
Drawworks:
1959 National T-12 Single Drum Drawworks powered by 525 HP Series 60 Detroit Diesel, Drum grooved for 1” line, Foster makeup & breakout catheads, air drillers controls. (Rebuilt July 2007, replaced all bearings, clutches, sprockets & chains)
Derrick:
1960 model 90 feet 6 inch, 300,000 lb, P.J. Jackknife Derrick, PJ Crown Sheaves, 4” 4000 psi standpipe, racking board, and ladder. (Crown sheaves rebuilt July 2007)
Substructure:
None
Powered Pumps:
#1 Wilson 600 Duplex, 6 ½” by 14” 600 HP max at 95 spm. forged steel fluid end w/ quick-change caps, relief valve, pressure gauge, master skid, powered by 600 HP John Deere with air clutch. Normally stocked with 5 ½” & 6” liners. (Pump rebuilt July 2007)
Dog House & Fuel Tank Skid:
Dog House: 8’ width x 20’ length skid mounted, insulated doghouse with knowledge box, lockers, G.H. Bear automatic driller, Electric heat.
Fuel Tank: 3,000 gallon diesel fuel tank mounted on skid with dog house
Water Tank :
125 bbl, 7’ 1” width x 10’ 1” length x 15‘ 2” height water tank mounted on pipe tub
Generator Set:
Kholer 30 kw light plant power by 4 cylinder John Deere diesel.
Recording & Monitoring Equipment:
Rig equipped with Double Pen Geolograph (Rebuilt Spring 2007)
Handling Tools & Auxiliary Tools:
BJ Style Type C tongs with heads sizes from 3 ½” to 10 3/4”.
4 ½” Drill Pipe slips
5 ½” through 7” Drill Collar slips
Drill Collar Safety Clamp
Elevators: 4 ½” BN, 4 ½” casing, 5 ½” casing, 8 5/8” casing
Cat head & Boom line, both with 1” rope
Martin Decker Clipper Weight Indicator
4” ID Rotary Hose
1 Center Tub with 10 foot casing extension,
4 Pipe Tubs
Sure Shot deviation tool with wire line unit
Rotating & Traveling Equipment:
Gardner Denver 17 ½” Rotary Table
TSM 150 Swivel
4 ¼” square Kelly 37.10 feet overall length, 35.75 working length
Varco square drive Kelly drive bushings
Rat Hole and Stand pipe on Driller Side
EMSCO 100 ton, 6 line traveling blocks with BJ 540 hydra-hook
1” Drill Line
2 3/8” X 96” Elevator Links
Drill Pipe & Drill Collars:
14 each 6 ½” 96 #/ft 4 ½” XH Thread, HB, Slip Recessed Drill Collars (6 1/2” OD, 2 ¼” ID)(New July 2007)
5000 feet of 4 ½” 16.6 #/ft Grade E Drill Pipe with 4 ½” XH HB BN tool joints
Change Over Subs with Rig:
1 each Bell Sub 6 5/8 Regular box by 4 ½” XH Pin, 26” long, 8” OD top, 6 ¼” OD Bottom
1 each 4 ½” XH Box by 4 ½” Regular Box with float cut out