rig-11

Rig # 11 Inventory
750 HP

Drawworks:
2005 SCHRAMM T130DX powered by Detroit Diesel DDC/MTU 12V-2000TA DDEC 750 BHP @ 1800 rpm.

Feed System:
130,000 lb Pull up capacity. 32,000 lb pull down capacity.

Carrier:
CCC 8X4 Carrier. Cat C-13, 410 hp @ 2100 engine, 44,000 lb front axles, 21,500 lb pusher axles, 52,000 lb rear axle, 117,500 lb GVWR

Top Drive:
Ductile iron, single reduction oil bath gearbox with two disc valve type hydraulic motors. Infinitely variable rotation speed. 3.5:1 Reduction Gear. 0 – 143 rpm. 106,000 in-lb torque.

Mast:
Telescoping constructed mast, 69 ft 9 in overall height extended, 42 ft 9 in retracted. Can handle Range III pipe up to 44.5 feet in length.

Substructure – 2 feet:
2’ height x 12’ wide substructure with back-on ramp with 6 feet floor.

Mud Pump:
#1 EMSCO D175 Duplex pump., fluid end w/ quick-change caps, relief valve, pressure gauge, master skid, powered by 375 HP John Deere with air clutch. Normally stocked with 6” & 6 ½” ” liners.

Water Tank:
125 bbl, 7’ 1” width x 10’ 1” length x 15‘ 2” height water tank mounted on pipe tub.

Dog House & Fuel Tank skidded together:
8’ width x 6’ height x 10’ length, 3,000 gallon diesel fuel tank.

Generator Set:
30 kw generator.

Recording & Monitoring Equipment:
Double pin geolograph. Martin Decker Pressure & Torque gauges.

Handling Tools & Auxiliary Tools:
BJ type C tongs with heads sizes from 4 ½” to 6 1/2”.
Air Slips with 4 ½”, 5 ½”, 7”, 8 5/8”, 9 5/8” casing slips
Pick up Subs: 4 ½” casing, 5 ½” casing, 7” casing, 8 5/8” casing, 9 5/8“ casing, 13 3/8” casing
Drill Collar Safety Clamp
Hydraulic pipe handling winch
Martin Decker Weight Indicator
Rotary torque gauge
3 ½” ID Rotary Hose
Sure Shot deviation tool with wire line unit
1 1/8” Drill Line

Well Control Equipment:
Washington Model 1358 non-rotating diverter with 7” outlet and with Washington 4010-C 4 ½” stripper rubber

Drill Pipe & Drill Collars:
6 each 6 ½” 96 #/ft 4 ½” XH Thread, HB, Slip Recessed Drill Collars (6 1/4” OD, 2 ¼” ID)
2,500’ 4” S-135 bottle neck drill pipe with 4” full hole connections

rig-11-site